|
|
|
|
Beer Line Cleaning Kit Directions
Cleaning your draft beer system is easy, and the more
you do it, the easier it gets. |
 |
Step 1 - Prepare
- Shut off the CO2 tank by turning the valve in a clockwise motion;
- Mix one quart of warm water and 1 tablespoon of Beer Line Cleaner
in a 1 gallon bucket;
- Fill the Plastic Jar with the mixture of water and cleaner from the bucket.
Step 2 - Soak and Scrub Parts
- Disconnect the coupler from the keg;
- Unscrew the hex nut on the beer line from the top of the keg coupler;
- Using the Spanner Wrench, remove the faucet from the tower or shank. Take the faucet apart and set it in the remaining mixture in the bucket to soak;
Step 3 - Flush Out Lines
- Connect the Pump Assembly from the Plastic Jar to the faucet shank coupling nut with the Rubber Washer in between;
- Tighten slightly with the Spanner Wrench and place the end of the beer line into the bucket;
- Pump the solution through the beer line to clean.
Step 4 - Final Wash
- Now, using the Cleaning Brush, scrub out all of the faucet parts that have been sitting in the Beer Line Cleaning solution. Rinse all parts under cool, fresh water and then reassemble;
- Disconnect the Plastic Jar and rinse it with cool, fresh water;
- Fill it up with fresh water and reconnect it to the faucet shank coupling nut;
- With the end of the beer line in the bucket, pump fresh water through the beer line.
Step 5 - Reassemble
- Disconnect the Plastic Jar, replace the assembled faucet, and tighten the coupling nut with the Spanner Wrench;
- Attach the beer line and tap your keg!
|
Deluxe Beer Line Cleaning Kit
Economy Beer Line Cleaning Kit
Beer Line Cleaner |
|
|
|
|
|
|
|
|
Main Categories:
|
More Info: |
|
|
|
|
|
|
|
|
