#6 Drilled Rubber Stopper

Add to your stock of homebrew supplies with this drilled rubber stopper.

Made of solid rubber with a drilled hole that’s perfectly sized for an airlock, this plug is perfect for keeping oxygen away from your fragile fermentation.

Just pop this #6 drilled rubber stopper into the mouth of your carboy or fermenter, insert an airlock, and let nature do the work!

Please note: For best results, measure the diameter of the mouth of your carboy or fermenter and compare to rubber stopper measurements to find a good fit.

Features

Made of rubber
Creates an airtight seal in the mouth of your carboy or fermenter

Free Expert Support

877.636.3673

Contact Customer Care

Specs

Dimensions: 1 1/16” Bottom Diameter; 1 1/8” Top Diameter

WARNING: This product contains a chemical(s) which is known to the state of California to cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Related Products

Powered by TurnTo

Review More Purchases | My Posts

There are no reviews for this item. Write Review

Powered by TurnTo

Questions that need answers | My Posts

Start typing your question and we'll check if it was already asked and answered. Learn More

Browse 2 questions Browse 2 questions and 2 answers

Why did you choose this?

Kegworks Store

I am fermenting sauerkraut and it's cheaper to dyi these than buy in "fermenting kit"

Cynthia H on Mar 4, 2017

I am fermenting sauerkraut and it's cheaper to dyi these than buy in "fermenting kit"

Cynthia H on Mar 4, 2017

what size bung fits a 2 inch hole?

Bondo on Mar 15, 2016

BEST ANSWER: I don't know whether or not your speaking about an actual 2" hole or a nominal sized 2" hole, threaded or unthreaded. Generally a 2" hole has a range between 2" thru 2 5/16". So my best advice to cover the range would be to find a tapered bung with a small diameter of 1 7/8" up to a large diameter of 2 1/2".

Reply
Inaccurate
RJ'S on Mar 23, 2016
Purchased on Sep 10, 2014

0

BEST ANSWER: I don't know whether or not your speaking about an actual 2" hole or a nominal sized 2" hole, threaded or unthreaded. Generally a 2" hole has a range between 2" thru 2 5/16". So my best advice to cover the range would be to find a tapered bung with a small diameter of 1 7/8" up to a large diameter of 2 1/2".

Reply
Inaccurate
RJ'S on Mar 23, 2016
Purchased on Sep 10, 2014

0

Hi Mark, a 2" opening is slightly larger than a standard carboy. The #10 1/2 might work, but the top diameter is only 2 1/16". For best results, measure the diameter of the mouth of your carboy or fermenter and compare to rubber stopper measurements to find a good fit. Hope that helps! Cheers!