Draft Beer Tower Shank Locknut
Roll Over Image to Zoom
$2.99
In stock and ready to ship.
This durable brass shank locknut is a quick and easy replacement kegerator part for your worn out nut and holds the beer shank in place.
- Overview
-
For your draft beer tower to work as intended, all parts needs to be in fine working order. One part that periodically needs to be replaced is the shank locknut.
The shank locknut is used on the inside of your refrigerator and is designed to hold the shank in place. Once you drill the hole through the wall and slide the shank through, the locknut is inserted on the threaded pipe and tightened to a snug fit.
Made of solid, durable brass, this replacement beer shank locknut is the perfect solution if your old nut is leaking or stripped. It will fit all standard beer shanks.
Installing your new shank locknut is about as easy as it gets. Just loosen and take off your old locknut, then use a wrench to tighten this one in its place.
Features
- Replacement locknut for draft beer tower
- Used to hold the shank in place inside refrigerator
- Replaces damaged, stripped, or leaking locknuts
- Made of solid brass
- Fit standard US shanks
- Easy to install
- Specifications
-
Specs
- Thread size: 7/8” x 14 female straight pipe thread
WARNING: This product contains a chemical(s) which is known to the state of California to cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. - Shipping & Delivery
-
Related Products
- Customer Reviews
- Questions & Answers
- Start typing your question and we'll check if it was already asked and answered. Learn MoreBrowse 2 questions Browse 2 questions and 6 answersWhy did you choose this?Kegworks StoreNeeded them as I had to cut the old ones off and I wanted a couple spares.Bruce J on Oct 8, 2019my old one is getting beat upGeorge P on Apr 28, 2018Needed them as I had to cut the old ones off and I wanted a couple spares.Bruce J on Oct 8, 2019Mine were old and breakingDaniel C on May 28, 2019Does this nut use a 1 inch or a 1-1/16 inch wrench?BEST ANSWER: I use a screwdriver and a hammer. I guess you could use a crescent wrench.
- Reply
- Inaccurate
- Alan K on Dec 18, 2019
- Purchased on Dec 15, 2018
-
If You Like This, You May Also Like
About Backorders
This item is currently out of stock but we're expecting more soon.
For an estimated ship date, please contact Customer Care at 877.636.3673 or email customercare@kegworks.com.
