KegWorks Homepage
-
This elbow has a barbed end to fit a 3/16" beer line and a smooth end to fit a compression fitting on the back of the shank of the beer tower dispenser. Parts like this basic elbow fitting can easily increase draft beer system efficiency.
This elbow fitting attaches your beer line to the back of draft beer towers with faucet shanks that attach with compression fittings. To attach, use a brass nut and rubber grommet (sold in a kit separately) between the elbow fitting and the shank.
Note: Before you order, check the parts used in your tower shank to make sure the elbow is attached with a compression fitting and not a welded-on elbow.
-
- Made of 304 stainless steel
- Prevents kinked lines
- Used with a compression fitting in a tower shank
- Smooth end fits compression fitting on back of tower shank
- Barbed end fits 3/16" beer line
-
- 1 1/2"L x 1 1/2"W
- 5/32" inside diameter
- 1/4" outside diameter
- null
- null
- null
- null
-
Attention CA Residents:
Prop 65 Warning >
This product may contain a chemical(s) which is known to the state of California to cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
The KegWorks Difference We're Your Favorite Drinking Buddy
Entertain & Inspire
We believe in creating and sharing good beverages. And having a damn good time doing it.
Educate & Inform
From troublshooting draft systems to crafting the perfect cocktail. We've got you covered.
Unique Product Selection
Your one-stop shop for the unique bar products you just have to have.
Exceed Expectations
Here to help. We aim to be the go-to source for all drink enthusiasts.