-
Cool the beer lines running from your commercial refrigerator or walk in cooler to your draft tower with this large forced air blower.
Keeping your beer lines chilled maintains the temperature of your beer as it travels to your tower and faucet to maintain its integrity and minimize foaming. This blower circulates cold air from the cooler through a duct carrying the beer lines to the faucet as part of a forced air, long draw draft system.
The 273 CFM (cubic feet per minute) blower provides economical air delivery powered by a Dayton PSC motor rated for continuous duty so it will hold up to being used with your draft system. Direct drive blower wheels are dynamically balanced to reduce noise and vibration and to maintain CFM at higher static pressures. The durability of this unit is further strengthened by its heavy gauge steel housing and permanently lubricated ball-bearings.
The forced air blower includes a 3" mounting bracket and discharge flange adapter to install the unit near the fan or condenser unit inside your cooler to ensure the coldest air is fed into your hose. The blower features an 8' power cord for easy installation.
Draft system blower is intended only for use in large commercial grade refrigeration units or walk-in coolers, this is because the blower generates considerable heat which residential grade and small commercial grade refrigerators simply do not have the cooling capacity to overcome.
This forced air long draw system is recommended for draft systems with eight (8) taps or less. A single duct system will work with runs of up to 15' and double duct systems are good for runs of up to 25'. A glycol chilled system would be recommended for larger draft systems.
-
- PSC motor
- Baked enamel gray finish
- Heavy gauge steel housing
- Cast aluminum end shields
- All position mounting
- Permanently lubricated ball-bearings
- Extruded aluminum blower frame for increased rigidity
- Auto-thermal protection
- Conduit box with 7" lead length
- Not suitable for use with speed-controlled devices
-
- Overall Dimensions: 9 7/8"H x 7 11/16"W x 8 7/8"D
- Outlet Dimensions: 3 5/8"h x 4 1/8"W
- Inlet Diameter: 4 5/8"
- Drive Type: Direct Drive
- Wheel Type: Forward Curve
- Mounting Position: All Positions
- Housing Material: Rolled Steel
- Housing Finish: Enamel
- Housing Color: Gray
- Bearing Type: Ball
- Motor Enclosure: Open
- Motor Insulation: Class B
- Blower Motor Type: Permanent Split Capacitor
- Blower Wheel Diameter: 5 1/8"
- Blower Wheel Width: 3 11/32"
- Blower Outlet Shape: Rectangular
- Lead Length: 13"
- Maximum Ambient Temperature: 104°F
- Maximum Inlet Temperature: 104°F
- CFM (Cubic Feet per Minute): 273
- RPM: 1640
- Full Load Amps: 0.77
- Blower Voltage: 115VAC
- Hz: 60/50
- Phase: 1
- Power Cord Specs:
- 3-Wire 16 Gauge
- Rubber Covered
- 8' Length
- 10 Amp Max
- Round Cable
-
- (1) 273 CFM Blower
- (1) 3" Mounting Bracket
- (1) Discharge Mounting Flange
- (1) 8' Power Cord
- N/A
- N/A
- null
-
Attention CA Residents:
Prop 65 Warning >
This product may contain a chemical(s) which is known to the state of California to cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.