-
Our 90-degree brackets attach securely to both the face of your bar (or wall) and the floor for extra stability. In a straight, 6" x 6" design, these bar foot rail brackets are built for simplicity in measuring and placing them during installation.
These brass brackets with satin brushed finish sit exactly 5.15" from the floor to the bottom of the tubing opening and 5.15" from the bar face to the edge of the tubing opening. With two contact points, this double-footed bar rail bracket combines a sturdy build and a practical design. For proper support, bar rail brackets should be placed at each end of the tubing, plus one for every 4-foot increment.
The angular design of this bracket really accents the look of your foot rail, while the brushed brass finish will precisely match your Brass 1.5" square bar rail tubing.
For help deciding which bracket will work best for your bar project, check out our bar foot rail brackets guide for more information on each option.
Installation instructions:
- Measure & mark holes for mounting screws.
- Attach brackets to the face of the bar and floor with the 8 mounting screws.
- Secure tubing to bracket by fastening set screws through hole in the bottom of bracket.
For more detailed instructions on how to install bar rail read our guide to planning & installing.
Care & Maintenance:
Care and maintenance of bar foot rail varies by finish. Given the nature of the product, typical wear and tear may be noticed with your bar rail over time, such as scuffs, scratches and dirt. Our guide to cleaning & maintenance on how to properly prep, clean & maintain all bar rail finishes.
-
- Made of brass with a satin brushed finish
- For use with 1.5" square bar rail tubing
- Bracket arm mounts to the face of bar and floor
- Brackets should be used at both ends of rail tubing, plus one at every 4' increment
- Mounting screws included
- Suitable for indoor use only (Clear coat protection available by request)
-
- Bracket Width: 6.00”
- Bracket Height: 6.00”
- Opening Diameter: 1.7” (for 1.5" square tubing)
- Wall to Edge of Tubing: 5.15”
- Floor to Edge of Tubing: 5.15”
-
- (8) #10 1-1/2" Mounting Screws
- (1) #8 3/4" Self-Drilling Set Screw
-
Attention CA Residents:
Prop 65 Warning >
This product may contain a chemical(s) which is known to the state of California to cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.