Leaking CO2

Once again KegWorks is the place to keep your beer flowing!!

Double check fitting sizes

Must have missed it in the description, not all sankey are the same. Only one of the fitting I purchased was the right size. All others were too small or big. Double check before you purchase. For the price of the kit I should have just purchased new coupler. .

Sanke seals

Exactly what I needed. Old Seals were hard from sitting idle. New seals fit my sanke perfectly. Now this Buds for me.

Be Aware It Doesn't Fit All Couplers

Good value for the cost. Be aware the probe o-rings don't fit all couplers. I used on some micromatic couplers and it led to leaks.

Repair kit

As described- fit perfectly.

Not good

Half the parts don’t fit

The big washers fit but nothing else. Too many different taps.

Be prepared to wait a month

Ordered a couple of items to test them out. Parts that finally arrived were as expected, but the first shipment was missing a few items, an unpleasant surprise. Contacted customer service and they resent the missing items. Another week goes by and another shipment that was still missing half the items arrived. Took them 3 tries to send all of the parts to rebuild 6 couplers, not a big order and should have been an easy fulfillment.

Fine product, wrong coupler

The kit is perfectly fine, for the correct coupler. Just not for the micromatic Sankey D couplers we have. I would suggest adding the gasket dimensions to the page, but ultimately, caveat emptor

Not right

Sent the wrong kit, cost me $ 4 to send it back

Fit issues

It’s is advertised as all Sanke couplers. however it only fits my perlick couplers. Does not for Micromatic couplers. They are a different size and type. Need to clarify

It was the wrong items.The 3 O Rings on the shaft are smaller. I cleaned and re-used the old ones.The gas ****** was also wrong. I use only Co2

Exactly as specified

Worked perfectly and did the job!

I have not rebuilt my Sanky yet. I’m sure all the parts will work fine.

Worked

All the parts I needed for a refresh!

Does not work with Micro Matic keg couplers

Its my own fault for not looking more closely at what I had before ordering. This kit does not work with Micro Matic keg couplers. Had to return for refund.

None of the gaskets fit my keg coupler. I originaly purchased the coupler from Kegworks as part of a fridge conversion kit, and I spoke with customer service before ordering this repair kit that they said would fit. It would be really nice if KegWorks would list the actual dimensions of parts !

Why is Rebuilding a Sankey Tap so Complicated

I must be missing something, I know that there are two lengths of Sankey coupler, the old (short) for domestics and the new (long) for most imports, but sheesh!I bought a kit from a local shop, well over twice the price of the Kegworks kit. The washer on the tap portion wasn't close, plus it had only two internal O rings, my coupler had 3... The Kegworks kit had the perfect tap end washer, most of teh other parts fit perfectly, but the three internal O rings were way too small diameter to fit.Between the two kits and reusing an O ring it works.

I need to rebuild 4 or 5 couplers. This kit will save me time and money.

The bottom washer that seals to the keg and coupler needs to be thinner too thick